System Utilities 2-23
During the flashing procedure, do press any key. (Figure 2-27)
Figure 2-27. DMI Flash Procedure
When the DMI flash procedure is completed, the following screen will appear, as shown in
Figure 2-28.
Figure 2-28. DMI Flash Completed
11. Restart system after flash has completed.
12. Press DEL to enter setup when the splash screen displays.
13. Check to see if BIOS is correct.
14. Press F9 to load default settings.
15. Press F10 to save the default settings and exit BIOS setup.
To Next Page
Loading...
