Acteon X-MIND unity - Transport and Positioning of the Mobile Stand

 !"##"$"%"&%*""#
Page ;@of (()XM_unity_Installation&Maintenance_Manual Ed.1.3c2013
=454 
The scissor arm is provided with the XRay source assembly (tubehead) already connected and installed.

3% !-0H &$"%/  3% -$0$ $. 3% "0* 0%#%2" $ 3% 8%3%"/ !/%
D0* E

! -0$2/%/ #$"/%/

.0$* 3%
."&$0 .$0!".% 0%"!$!4
 1" G 13% 0%*$2H 3% "!!%*8#  -"$H0"-3 "0* "/ 8%3%"/ .0$* 3% -"&F"H%G &3%&F 3" 3% *%&3"&"#
%!$!.## #$"/%/4


"  "%$
13%
*""HH 3% "!!%*8# 
-"$H0"-3
"0*

-#!
8%3%"/4 3! "!!%*8#  ! J% 3%"2  "/ ! "

%60%*%# /%#&"%-"04
" "%$*$2H3!"!!%*8# G1%!HH%!$*$2%3""!!3$18%#$1$8%*$0%&$*.$0"8#%/0H"!!%*8#H
$-%0"$!4

!F$.L0 R

$$.$#/-$00 $.$#/-3%!&!!$0"0*3%!"##%/!"%R"0%.## 0"!-$03%!&!!$0"0*3%
.$#/%/!"%4

"F%&"0%$.

3%

&"8#%!%6H.0$*8%DEG/$$-&3$0/"*"H%3%!%&"8#%!4

Fig.5.15
ASSEMBLY INSTRUCTIONS (refer to figures below)
1. Carefully remove the pantograph arm (scissor) from the packaging, pay attention when managing the scissor arm because the
tubehead is preinstalled in factory and the whole assembly results quite heavy and very delicate.
When transporting the assembly, it is suggested to carry the scissor arm on your shoulder as shown in the picture above.