Acteon X-MIND unity - Error Messages

 !"##"$"%"&%*""#
Page BBof (()XM_unity_Installation&Maintenance_Manual Ed.1.3c2013
('4 

In case of malfunctioning or error events, the display will show an error code together with acoustic signals (5 beeps). Furthermore
an error symbol code is shown on the display, warning the operator about the error status.
All functions are inhibited until the error status is fixed or restored.
Fig. 12.1
Some errors can be cleared by pressing the reset button
on the keypad.
The following chart gives a list of error messages that may appear while the  radiographic system is working.
Error codes are made by letter “E” followed by a number that identifies unit in fault (timer or tubehead) and other 2 numbers that
identify the error.
Unit number:
“(”: Fault it is located in the timer (control unit)
“'”: Fault it is located in the tubehead