Network · / actiNAS Manager
Network Adaptor Configuration Options
Shows the network device name. eth0 is the device name for LAN0 gigabit port.
Shows the current IP address of the network device. Configure the IP address as necessary.
Show the current IP address of the Gateway. To edit, enter the Gateway IP address
Shows the current subnet mask setting. To edit, type in the new subnet mask number.
The MTU size (Maximum Transmission Unit) in bytes. To modify the MTU size for this
interface, select the new MTU size. Options are: 1500 (default), 2000, 3000, 4000, 5000,
6000, 7000, 8000, and 9000.
Shows the MAC address of network device.
If enabled, this adapter will be active when actiNAS starts up
If checked, this specifies that this network device will dynamically obtain an IP address from
a Dynamic Host Configuration Protocol (DHCP) server or from a Bootstrap Protocol
(BOOTP) server
If checked, the default gateway will be enabled in this adapter. A default gateway is a local IP
router that is used to forward packets to destination beyond the local network. Only one
default gateway in the NAS can be enabled in a certain time.
Use this button to undo or clear any changes made.
Use this button to save the changes made.
Use this button to configure network trunking.
To Next Page
Loading...