2. Click Restore. The restore options are displayed.
Figure79: Restore Selected Backup File Features
3. Select the features you want to restore. By default, all features are selected. To unselect some of the features, simply
click the checkbox or use the Select All or Unselect All options.
4. Click Next.
5. Select the ENVYSION projects to restore and click Next.
Figure80: Restoring ENVYSION Projects
6. In the Confirmation section, review the selected features you selected and select Remove backup file after restore to
remove the backup file from the device after reboot.
7. Click Finish. The restore process may take a few minutes.
You cannot restore a “non-FIPS 140-2” to a FIPS 140-2 device because the file is not encrypted and therefore not compatible with the FIPS
140-2 mode.
You also cannot restore a backup which was created in a more recent firmware version than the one you are restoring to.
ECLYPSE Web Interface
79
nLight ECLYPSE
To Next Page
Loading...