Adaptec 5405 - Page 110

Chapter 9: Monitoring Status and Activity ● 110
Disabling Logged Notifications
Logged notifications are enabled by default. You can choose disable them on a selected system,
if required.
Note:
If you disable logged notifications, events will be generated for that system but not
broadcast—not even to the local Event Log.
To disable logged notifications:
1 In the Enterprise View, select the system you want.
2 On the tool bar, click Configure, point to the system, then click Notifications.
The Notifications Manager opens.
3 On the menu bar, click Actions, then click Disable notifications. (See the illustration in
Step 4 on page 108, if required.)
Event notifications are disabled. The Notifications tab (shown at right)
shows the red ‘disabled’ icon.
Re-enabling Logged Notifications
To re-enable logged notifications, repeat steps 1 and 3 in Disabling Logged Notifications,
selecting Enable Notifications during Step 3.
Clearing the Notifications Manager Log
The bottom panel of the Notifications Manager displays status information and messages
about the Notification Manager itself, such as whether notifications were sent successfully or
not. To make it easier to monitor recent events, you can clear the log on a selected system.
To clear the Notification Log:
1 In the Enterprise View, select the system you want.
2 On the tool bar, click Configure, point to the system, then click Notifications.
The Notifications Manager opens.
3 On the menu bar, click File, select Clear the event log, then click Notifications.
4 Click Ye s to clear the log.
The log is cleared.