EasyManuals Logo

adept technology Adept Cobra i600 User Manual

adept technology Adept Cobra i600
110 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
System Installation
26 Adept Cobra i600/i800 Robot User’s Guide, Rev G
PC Requirements
To run and use Adept ACE software, the following hardware and software are required.
NOTE: The specifications are also listed in the ACE PackXpert Datasheet,
available on the Adept corporate web site.
Hardware
Processor: Core2Duo 2.0 GHz or better
Disk Space: 500 MB recommended minimum
RAM: 2 GB or more
Monitor: SVGA, minimum resolution 800 x 600
Ethernet: (if using vision) IEEE 1394 or Gigabit-Ethernet support
Adept recommends using the Adept SmartVision™ EX vision processor
Serial cable: A standard, null modem, shielded, RS-232 data transfer serial cable,
DB-9 female connectors on both ends (supplied by Adept)
Software
Operating System: Microsoft Vista (32-bit), Microsoft Windows® XP with Service
Pack 2, Microsoft Windows® Server™ 2003 with Service Pack 1, or Microsoft
Windows® 2000 with Service Pack 4
Microsoft .NET Framework 2.0 or later (included in the installation of the Adept
ACE installer)
Microsoft Internet Explorer version 5.01 or later (necessary for viewing Online
help)
Installing Serial Cable
1. Locate the RS-232 null modem serial cable that is included in the Accessory Kit.
2. Connect one end of the serial cable to the RS-232 connector on the robot interface
panel. See Figure 3-1 on page 24.
3. Connect the other end of the cable to a serial port on the PC.
Serial ports are also referred to as COM ports.
3.5 Installing Adept ACE Software
You install Adept ACE from the Adept Software CD-ROM. Adept ACE needs Microsoft
.NET Framework. The Adept ACE Setup Wizard scans your PC for .NET, and installs it
automatically if it is not already installed.
1. Insert the CD-ROM into the CD-ROM drive of your PC. If Autoplay is enabled,
the Adept Software CD-ROM menu is displayed - see Figure 3-2. If Autoplay is
disabled, you will need to manually start the CD-ROM.
NOTE: The online document that describes the installation process opens
in the background when you select one of software installation steps
below.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the adept technology Adept Cobra i600 and is the answer not in the manual?

adept technology Adept Cobra i600 Specifications

General IconGeneral
Brandadept technology
ModelAdept Cobra i600
CategoryRobotics
LanguageEnglish

Related product manuals