Ados T060E - Setting T060 E Load Cell Signal; Setting T060 E Weighing System Capacity; Setting T060 E System Resolution; T060 E Average Settings for Filtering

1569‐PT060EE1 Rev.7 Page31of62
5.4.3 Setting the load cells’ signal
S E G N 1
Itisthesensitivityvalueoftheloadcell.Themaximum
allowedsignalis3.5mV/V.

5.4.4 Setting the weighing system capacity
P O R T 1
Itisthecapacityoftheweighing system.Themaximum
capacityconsistsof100000divisions.

5.4.5 Setting the system resolution
S E N S 1
Thevaluecanbeselectedwithintherangefrom50to0.001
divisions.Thesystemresolutionisgivenbytheratiobetween
capacityandresolution.Seealsopoint2.2.1

5.4.6 Average settings
M E D I E 1
This parameter is used for the digital filtering of  the weight
signal, in order to reduce the unwanted effects due for
example to mechanical vibrations that act on the weighing
system.Thehigheristheparameter’svalue,thegreateristhe
abilitytofilterunwantedoscillations,evenifthereisa
longer
delay in visualizing the variations of the weight signal. See
point2.2.4.

OFF

2

4

8

16

32

64

FIR 1
FIR 2
FIR 3
FIR 4
