Ados T060E - Setting Relay 1 Threshold Value; Setting Relay 1 Hysteresis Value; Setting Relay 1 Minimum Alarm Time; Setting Relay 1 Minimum Return Time

1569‐PT060EE1 Rev.7 Page33of62
5.4.10 Threshold value of relay 1
S E T R 1
Thisparameterdefinesthethresholdvaluetoassigntorelay
1.Seechapter2.5.


5.4.11 Hysteresis value of relay 1
D B R 1
Thisparameterdefinesthehysteresisvalueassignedtorelay
1.Seechapter2.5.


5.4.12 Minimum alarm time of relay 1
D A L R 1
Thisparameterdefinestheminimumtimetotriggerthealarm
ofrelay1.Seechapter2.5.


5.4.13 Minimum time to return to idle mode of relay 1
D O H R 1
Thisparameterdefinestheminimumtimeforrelay1to
returntoidlemode.Seechapter2.5.


Thecharacterisationparametersoftherelay1functionapplytoallfiverelays.
5.4.14 Enabling of FAIL function for channel 1
F A I
L
1


IfONallchannel’srelaysareforcedinalarmstatus.
IfOFFandnorelayisconfiguredasaFAIL,appearsonlyamessage.
5.4.15 Enabling of FAIL function for channel 2
F A I
L
2


IfONallchannel’srelaysareforcedinalarmstatus.
IfOFFandnorelayisconfiguredasaFAIL,appearsonlyamessage.