Ados T060E - T060 E Unbalanced Load Alarm Configuration

1569‐PT060EE1 Rev.7 Page39of62
5.4.31 Unbalanced load alarm setting

With this parameter it is possible to set an alarm when the value of the difference between the weight of the two
channels is greater than or equal to the set threshold value. The control is active for both positive and negative
weights.

S B I L A N


Theunbalancecheckisonlyactiveifthefollowingconditionsaresatisfacted:
1. T060Einstrumentsuppliedinthe"D"version(doublechannel)forthesimultaneouscontroloftwoweighing
channels
2. capacityofthetwosystemsequal(PORT parameter)
3. sensitivityofthetwosystemsequal(SENS parameter)
Iftheaboveconditionsarenotobserved,insertingtheunbalancingvaluetheinstrumentsignalsERROR.

Oncetheunbalancevaluehasbeenset,settherelaytobeassignedtothefunction(followingexamplewithrelay1).
S B I L A N
Thisparameterdefinestheunbalancedvalue
S E T R 1
Parameternotactive
D B R 1
Thisparameterdefinesthehysteresisvalueassignedto
relay1
D A L R 1
Thisparameterdefinestheminimumtimetotriggerthealarm
assignedtorelay1
D O H R 1
Thisparameterdefinestheminimumtimeforrelay1 to
returntoidlemode.
