Hybrid Standalone NVR User Guide 4 Web Service
4.7.2.11 Auto Register
The Auto Register page is shown below.
Figure 4-29
This function enables the device to automatically register to the proxy you have specified. In this way
you can use the client end to access the NVR via the proxy. In the network service, the device
supports a server address of IPv4 protocol.
To use the Auto Register function:
1. Set the proxy server address, port and sub-device name at the device end.
2. Enable the Auto Register function. The device automatically registers to the proxy server.
IMPORTANT: Do not input a network default port such as the TCP port number.
The proxy server software is developed from the SDK. Open the software and input the global
setup. Make sure the auto connection port here is the same as the port you set in the
previous step.
3. Now add the device. Do not input default port number such as the TCP port in the mapping
port number. The device ID used here must be the same as the ID you input in Figure 3-20.
4. Click the Add button to complete the setup.
5. Boot up the proxy server.
When you the network status is Y, the registration is OK. You can view the proxy server when
the device is online.
IMPORTANT: The server IP address can also be the domain but you must register a domain name
before you run the proxy device server.
4.7.2.12 Alarm Center
This feature is not currently supported by ADT.
NVR4200 Series User Guide
155
To Next Page
Loading...
Need help?
General