Hybrid Standalone NVR User Guide 3 Local Menu Operations
2. Go to Setting>Network >FTP. Set the FTP server information and the picture upload interval.
Enable the FTP function and click Save.
3. Go to Setting>Alarm. Select the corresponding channel, then enable the snapshot function.
Note: Activation Snapshot has higher priority than Schedule Snapshot.
Buzzer
Enable this function to sound an audible tone from the NVR when the alarm occurs.
Note: A network alarm is an alarm signal using TCP/IP. You can use NET SDK to activate a network
alarm. There is no type, anti-dither or alarm upload function.
3.4.3 Abnormality
The Abnormality screen enables you to set how you would like to notified when specified events
occur. Select between the HDD or Network tabs.
Figure 3-44
NVR4200 Series User Guide
75
To Next Page
Loading...
Need help?
General