ADTECH9 Series CNC Maintenance Manual
- 112 -
Unit : mm/min, mm/min, mm/sec, mm/min
Authority : Operation admin or higher
Default : 3000, 200, 1000, 3000
Effective time : Instant
Note : The feeding instructions such as G01, G02 and G03 move at the speed
of F instruction. If the F instruction isn’t specified in the program, the
above instructions move at the speed set by this parameter. If the F
instruction is specified, this parameter will be invalid.
The maximum feeding speed restricts the F instruction during
processing, i.e. no matter what F is set to, the actual speed can’t exceed
this parameter value. Setting this parameter will prevent the damage
caused by accidental speed programming error when calling processing
files.
004 Zero Return Mode
Range : 0~1
Unit : None
Authority : Operation admin or higher
Default : 0 (Program home)
Effective time : Instant
Note : 0 - Program home
1 - Mechanical home
Program home is that the coordinates go to home, i.e. in place.
Mechanical home requires external detection switch to locate the home
position; while home operation, move to specified home direction at
home speed, and move back slowly after signal is detected. At this
moment, move forward slowly when the signal is disconnected, and the
home operation completes when the signal is valid again. When the
servo Z phase enable switch in IO configuration parameters is enabled,
mechanical home will enable Z phase positioning as home position
automatically after signal reaches.
005 IO Filter Wave (restart)
Range : 0~8
Unit : None
To Next Page
Loading...
Need help?
General
