ADTECH9 Series CNC Maintenance Manual
- 39 -
Move cursor to select the parameter, enter the value and then press [EOB] to modify the parameter where
the cursor locates.
0 Caution
1. Numeric Input dialog box has two input methods: direct assignment and incremental assignment.
Direct assignment refers to assigning the entered number directly to the specified parameter, and
incremental assignment refers to assigning the sum of entered number and current value of the
specified parameter to the parameter;
2. Incremental input and direct input box have symbols on the left: '=' represents direct input, '+'
represents incremental input; the default mode is always direct assignment; to change to
incremental assignment, press the "UP/DOWN arrow" key
3.15.2. System parameters setting
The system parameters can be modified as follow:
Select the edit mode;
In the main menu, press [Parameter] to enter parameter setting interface;
Then, press the submenu key to select the parameter type (comprehensive, management …);
Move cursor to select the parameter, enter the value and then press [EOB] to modify the parameter where
the cursor locates.
3.16
System shortcuts
Numeric Input dialog box has two input methods: direct assignment and incremental assignment. Direct
assignment refers to assigning the entered number directly to the specified parameter, and incremental
assignment refers to assigning the sum of entered number and current value of the specified parameter to the
parameter; Incremental input and direct input box have symbols on the left: '=' represents direct input, '+'
represents incremental input; the default mode is always direct assignment; to change to incremental assignment,
press the "UP/DOWN arrow" key.
In the [Monitor] screen, under [Position] menu, press the 'O' key to bring up the G-code O program number
box to quickly switch to O block. Press the "EOB" to confirm, and press "Cancel" to return.
In the [Monitor] screen, under [Position] menu, press '←', '→' in "Manual mode" to trim spindle speed
quickly; if you press and hold it, the speed value will be accumulated quickly. Note that this feature is available
when the spindle is turned on and the current spindle speed is not zero; if the current speed is 0, please first set it
to non-zero value in MDI mode, and then perform the shortcut operation.
To Next Page
Loading...
Need help?
General
