ADTECH9 Series CNC Maintenance Manual
- 87 -
10.
System parameters
According to occasions and functions, the parameters contain comprehensive parameters, IO configuration
parameters, management parameters and coordinate setting parameters.
Comprehensive parameters are complete, and contain basic operation and usage settings of the controller,
including spindles, handwheel, home, tool magazine, etc.;
IO configuration parameters are mainly used for machine installation and test, adapting to the interface
characteristics of machine tool and motor driver;
Coordinate setting parameters are tool setting configuration in [Coordinate] interface;
(1)It is required to confirm user identity to modify the parameter table. The controller has two levels of user
authority, which are super user and operator; super user can modify all parameters and user passwords; while
operator only can operate the parameters that require modification, and modify the operator password; in P3.1 in
management parameters, the system will enter the corresponding mode automatically according to the entered
password.
(2)According to the application, the parameters will take effect immediately or after restarted; the parameters
that require restart are marked with <●>.
(3)Certain parameters are set in binary system (parameter descriptor has bit symbol); the conversion between
binary system and decimal system is as follows:
Bit0: Set to 1 to correspond to decimal 1;
Bit1: Set to 1 to correspond to decimal 2;
Bit2: Set to 1 to correspond to decimal 4;
Bit3: Set to 1 to correspond to decimal 8;
Bit4: Set to 1 to correspond to decimal 16;
Bit5: Set to 1 to correspond to decimal 32;
Bit6: Set to 1 to correspond to decimal 64;
Bit7: Set to 1 to correspond to decimal 128;
For more bits, multiply the decimal digit corresponding to binary digit of previous position by 2. If only the
corresponding bit is 1, accumulate the numbers of corresponding decimal system according to the comparison
table to get the setting value.
For example: set Bit0, Bit1 and Bit5 to 1, and the setting value of parameter will be 1+2+32=35.
To Next Page
Loading...
Need help?
General
