ADTECH9 Series CNC Maintenance Manual
- 22 -
In [Absolute Position] and [Coordinate System] screen, press [X], [Y], [Z], [A] respectively to show the
value of corresponding axis position, and then press the [Cancel] key to reset the machine tool position of
current axis, i.e. current point is used as machine tool origin. After this operation, the system considers it as
a home action. Therefore, when the program is running, there will be no alarm of not returning to home. If
you press by mistake, it will switch the screen and cancel selection automatically.
3.5
Reset relative position manually
Press the mode switch key [Manual] to select manual operation;
In [Relative Position] and [Coordinate System] screen, press [X], [Y], [Z], [A] respectively to show the
value of corresponding axis, and then press the [Cancel] key to reset the relative position of current axis.
) Note
The tool also can return to reference point according to program instruction, i.e. returning to reference point
automatically.
0 Caution:
Generally, the system will perform home operation after connecting the power supply. If the power fails
while the machine tool is moving, the system shall also return to reference point when the power supply is
resumed. Return to Z axis first to prevent tool and workpiece from colliding, and damaging tool, workpiece
and clamp.
3.6
Continuous feeding manually
Press the keys on the operation panel or handwheel to move the tool along every axis.
The operation is as follows:
(1) Press the mode switch key [Manual] to select manual operation;
(2) Press composite keys [X+], [X-]; [Y+], [Y-]; [Z+], [Z-]; [A+], [A-] in numeric section to move the tool along
selected axis. The keypad is as follows:
To Next Page
Loading...
Need help?
General
