ADTECH9 Series CNC Maintenance Manual
- 134 -
Z Soft PosLimit+(mm)
Z Soft NegLimit-(mm)
A Soft PosLimit+(mm)
A Soft NegLimit-(mm)
B Soft PosLimit+(mm)
B Soft NegLimit-(mm)
C Soft PosLimit+(mm)
C Soft NegLimit-(mm)
Range : -9999~9999
Unit : mm
Authority : Operation admin or higher
Default : Maximum positive/negative value
Effective time : Instant
Note : Generally, the machine tool has hard limit signal. In this case, software
limit isn’t required. Please set the positive limit to +9999.999, and
negative limit to -9999.999.
If hard limit switch isn’t installed, please use soft limit, which uses
machine tool coordinate system as the base point. Positive limit and
negative limit are subject to actual distance (unit: mm).
Since soft limit decelerates and stops at the limit point, it may exceed the
set distance, which depends on acceleration time and speed. Please keep
certain margin when setting this parameter.
006
X- Machine Limit Input Port No.
Y- Machine Limit Input Port No.
Z- Machine Limit Input Port No.
A- Machine Limit Input Port No.
B- Machine Limit Input Port No.
C- Machine Limit Input Port No.
Range : 0~8888
Unit :
Authority : Operation admin or higher
Default : 0
Effective time : Instant
To Next Page
Loading...
