BYB User Manual Page 17 of 55 PN: 90020 Version: 1.4
With the lift assembly still on the trailer position the material handler to lift the portion of the package closest
to the trailer tongue (figure 2.3) using a strap as shown. Position a wheeled car dolly underneath the
shipping bracket and lower on to the dolly. Wood blocking may be necessary.
Figure 2.3: Material Handling Lift in Position
With the one side of the package assembly securely resting on the car dolly, the material handler may now
be re-positioned to the rear of the trailer and the strap attached to the rear section of the package. Raise the
packaged assembly upward so the rear section clears the car trailer and carefully roll the entire lift assembly
backwards bringing the front of the packaged assembly safely short of the rear of the car trailer. The lifted
end may now be carefully lowered and placed on a car dolly that is positioned on the ground. (Figure 2-4)
With one end of the packaged assembly on the ground, the material handler can now be re-positioned and
secured to lift the opposite end that is resting on the car trailer. Raise the packaged assembly to clear the
car trailer and drive the trailer out from under the supported assembly. Place a car dolly underneath the
raised end so that both ends rest on dollies on the ground. (Figure 2-5)
To Next Page
Loading...