ADAM-4000 Series User Manual 212
4069
7.1.15 AAS
Name Change and Read the Low Power Mode of Module command
Description The command requests the module at address AA to change
and return the status of low power mode of module
Syntax $AAS(cr)
$ is a delimiter character.
AA (range 00-FF) represents the 2-character hexadecimal
address that you will access to.
S is the Change and Read the Low Power Mode of Module command
(cr) is the terminating character, carriage return (ODh).
Response !AAX(cr) if the command was valid.
?AA(cr) if an invalid command has been issued.
There is no response if the module detects a syntax or
communication error, or even if the specified address does not exist.
! is a delimiter character which indicates a valid command
? is a delimiter character which indicates an invalid command
AA (range 00-FF) represents the calibrated 2-character
hexadecimal address of the module.
X represents the Status bit from the low power status. When
the logic is 1, it represents low power. However, if the logic
is 0, it is normal
(cr) is the terminating character, carriage return (0Dh).
To Next Page
Loading...
Need help?
General
