AIMB-584 User Manual 72
Memory Frequency Limiter [ Auto ]
Maximum Memory Frequency Selections in Mhz.
Max TOLUD [ Dynamic ]
Maximum Value of TOLUD. Dynamic assignment would adjust TOLUD auto-
matically based on largest MMIO length of installed graphic controller.
Enh Interleave Support [ Enabled ]
Enable or disable Enhanced Interleave support.
RI Support [ Enabled ]
Enable or disable Rank Interleave support. NOTE: RI and HORI can not be
enabled at the same time.
DLL Weak Lock Support [ Enabled ]
Enable or disable Dll Weak lock support.
Mc Lock [ Enabled ]
Enable or disable capacity to lock or not MC registers.
3.4 Boot Setting
Setup Prompt Timeout
User the <+> and <-> keys to adjust the number of seconds to wait for setup
activation key.
Bootup NumLock State [ On ]
On or Off power on state for the NumLock
Quiet Boot [ Disabled ]
If this option is set to disabled, the BIOS displays normal POST messages. If
enabled, an OEM logo is shown instead of POST messages.
Boot Option #1/#2
Choose boot priority from boot device
To Next Page
Loading...
