AES 7707 - 9 System Settings; Product License; Change Password; Add User

AES 7707 RF Subscriber 39
Part No. 40-7707 Rev. 3a 10/23/2017
 IP Address
 Subnet Mask
 Gateway
 DNS Server 1
 DNS Server 2 (Optional)
Obtain information for these settings from the network administrator or other individual who manages network
services.
9. System Settings
The System tab provides access to system setting features.
9.1 Product License
Subscriber product license information is displayed in this panel.
9.2 Change Password
Change Password allows the logged in user to set another password for the login account. If the user is logged in
with a default account password, a warning about changing the password appears in red letters.
The Login User line displays the current user logged into the Subscriber.
To change the password:
1. Enter the existing password into the “Current Password” field.
2. Enter a new password into the “New Password” field.
3. Re-enter the new password again into the “Confirm” field.
9.3 Add User
Add User allows you to add additional users to the system.
To add a user:
1. Enter the user name into the “Username” field.
2. Enter the password into the “Password” field.
3. Re-enter the password again into the “Confirm” field.
4. When through, click the Add User button.
9.4 Buzzer – Onboard Subscriber
The buzzer control enables or silences the onboard Subscriber buzzer. The onboard buzzer can be silenced when a
remote annunciator is used. The default setting is Enabled.
1. To disable, click the Enable control so that it changes to Disabled.
2. When through, click the Save Change button.
9.5 Uploading/Downloading Settings
Download Current Settings
Setting information can be downloaded from the Subscriber. Click the Download button.
Upload Preconfigured Settings
To upload Subscriber settings to the Model 7707, click the Choose File button, select the file, and click the Upload
button.
Reset to Default Configuration
Subscriber and IntelliPro settings can be set to factory defaults.
1. Set the Subscriber Config and/or IntelliPro Config switch to Yes.
2. Click the Reset Configuration button.
Note: Reset with Subscriber Config does not change the existing Subscriber ID and cipher code programmed into
the unit.