90 16900 Series Logic Analysis Systems Installation Guide
5 Setting Up Multiframe Configurations
If the application starts without errors, and you see the multiframe
system in the Overview window, you are ready to use the multiframe
system.
6 If you are not able to see the multiframe system in the Overview
window, do the following:
a Exit the Agilent Logic Analyzer application.
b Power down all systems.
c Disconnect and reconnect all multiframe cables to all chassis.
Re- verify the connection order. It should be Master (Output) ->
Slave1 (Input); Slave1 (Output) - > Slave2 (Input) and so one.
d Power up the systems as per the startup sequence described in Step
4.
e When all systems are ready, start the Agilent Logic Analyzer
application on the system from which you want to control the
multiframe setup. Wait for the application to stabilize.
To Next Page
Loading...
Need help?
General
