Agilent Technologies 5100 ICP-OES Service Manual

Agilent 5110/5100 ICP-OES Service Manual Agilent Restricted 191
7 Service Diagnostics and Fault Finding
Configure Instrument IP Address
2 Click on “Local Area Connection”.
3 Click on “Properties”.
4 Click on “Version 4 (TCP/IPv4)”.
5 Change the IP address to 192.168.1.127 and Subnet mask to 255.255.248.0 then click on OK.
Configure Instrument IP Address
If the IP address / network settings for the instrument require modification the following web
utility can be used.
The default network settings for the Agilent 5110 ICP-OES are as follows:
1 Enter the IP address of the instrument (in this case 192.168.1.128) into the address bar to
bring up the Agilent IP utility software.
The screen above will show the status of the instrument connection. Connection status “Idle”
and the serial number of the instrument will be displayed if there is a connection.
Host Name Defaults to the instrument serial number
Allocation Static
IP Address 192.168.1.128
Network Mask 255.255.255.0
Gateway 0.0.0.0

Agilent Technologies 5100 ICP-OES Specifications

General

Brand	Agilent Technologies
Model	5100 ICP-OES
Category	Laboratory Equipment
Language	English