11-30 Programmer’s Guide
SCPI Command Summary
SCPI Device Command Summary
Table 11-12 INITiate
Table 11-13 INPut
1. Binary parameters accept the values of 1 (on) and 0 (off) in addition to ON and OFF.
SUBSYSTEM COMMANDS FORM DESCRIPTION
INITiate[1|2]:CONTinuous
<ON|OFF>
1
NR1 Sets the trigger system to
continuously sweep or to stop
sweeping.
INITiate[1|2][:IMMediate] command
only
Initiates a new measurement
sweep.
SUBSYSTEM COMMANDS FORM DESCRIPTION
INPut:GAIN:AUTo <R|A|B>,<ON|OFF> command
only
Sets the R, A, or B IF input
automatic gain control on or off.
INPut:GAIN:SETTing <R|A|B>,
<HIGH|MEDHIGH|MEDIUM|LOW>
command
only
Sets the R, A, or B IF input gain
to one of four choices: high,
medium-high, medium, or low.
To Next Page
Loading...
