Programmer’s Guide 11-29
SCPI Command Summary
SCPI Device Command Summary
Table 11-11 HCOPy (2 of 2)
1. For DEVice, use 1 for PCL/Epson printers, or 2 for plotters.
2. For DEVice, use 1 for PCL/Epson printers, 2 for plotters, and 3 for PCL5 printers.
3. Binary parameters accept the values of 1 (on) and 0 (off) in addition to ON and OFF.
SUBSYSTEM COMMANDS FORM DESCRIPTION
HCOPy:DEVice[1|2]:RESolution
<num>
1
NR1 Sets the printer resolution in dots
per inch.
HCOPy[:IMMediate] command
only
Initiates a hardcopy output (print
or plot).
For DEVice, use 1 for PCL/Epson
printers, or 2 for plotters.
HCOPy:ITEM[1|2|3]:ANNotation
:STATe <ON|OFF>
1, 2
NR1 Turns on/off channel and
frequency annotation as part of
hardcopy output.
HCOPy:ITEM[1|2|3]:FFEed:STATe
<ON|OFF>
1, 2
NR1 Turns on/off an automatic form
feed at the completion of
hardcopy output — use item 1 for
printers and 2 for plotters.
HCOPy:ITEM[1|2|3]:GRATicule
:STATe <ON|OFF>
1, 2
NR1 Turns on/off graticule as part of
hardcopy output.
HCOPy:ITEM[1|2|3]:MARKer:STATe
<ON|OFF>
2, 3
NR1 Turns on/off marker symbols as
part of hardcopy output.
HCOPy:ITEM[1|2|3]:TITLe:STATe
<ON|OFF>
2, 3
NR1 Turns on/off title and clock lines
as part of hardcopy output.
HCOPy:ITEM[1|2|3]:TRACe:STATe
<ON|OFF>
2, 3
NR1 Turns on/off trace data as part of
hardcopy output.
To Next Page
Loading...
Need help?
General
