11-28 Programmer’s Guide
SCPI Command Summary
SCPI Device Command Summary
Table 11-11 HCOPy (1 of 2)
1. Binary parameters accept the values of 1 (on) and 0 (off) in addition to ON and OFF.
2. For DEVice, use 1 for PCL/Epson printers, 2 for plotters, and 3 for PCL5 printers.
3. EPSon and IBM produce the same results.
SUBSYSTEM COMMANDS FORM DESCRIPTION
HCOPy:ABORt command
only
Aborts any hardcopy currently in
progress.
HCOPy:DEVice[1|2|3]:COLor
<ON|OFF>
1, 2
NR1 Selects monochrome OFF or color
ON mode for hardcopy output.
HCOPy:DEVice[1|2|3]:LANGuage
<char>
2
CHAR Selects the language for
hardcopy output — choose from
PCL|HPGL|EPSon|IBM|PCX|
PCL5
3
HCOPy:DEVice[1|2|3]:MODE <char>
2
CHAR Selects the graph and/or table(s)
to appear on a hardcopy plot —
choose from
GMARker|GRAPh|ISETtings|M
ARKer|TABLe.
HCOPy:DEVice[1|2|3]:PAGE:MARGin
:LEFT <num>
2
NR2 Sets the left margin (for printer
output) in millimeters.
HCOPy:DEVice[1|2|3]:PAGE:MARGin
:TOP <num>
2
NR2 Sets the top margin (for printer
output) in millimeters.
HCOPy:DEVice[1|2|3]:PAGE
:ORIentation <char>
2
CHAR Sets printer output page
orientation — choose PORTrait
or LANDscape.
HCOPy:DEVice[1|2|3]:PAGE:WIDTh
<num>
2
NR2 Sets the print width (for printer
output) in millimeters.
HCOPy:DEVice[1|2|3]:PORT <char>
2
CHAR Selects the communications port
for hardcopy output — choose
from
CENTronics|SERial|GPIB|MM
EMory|LAN.
To Next Page
Loading...
