Agilent Technologies 8712ET - Page 237

Programmer’s Guide 11-39
SCPI Command Summary
SCPI Device Command Summary
Table 11-19 SENSe (2 of 16)
SUBSYSTEM COMMANDS FORM DESCRIPTION
SENSe[1|2]:CORRection:CKIT:LOAD
:MODify:DELay? #0~1e-06[S]#
NR3 Sets or queries the cal kit load
standard offset delay time.
SENSe[1|2]:CORRection:CKIT:LOAD
:MODify:LOSS? #0~1e+12#
NR3 Sets or queries the cal kit load
standard offset loss value.
SENSe[1|2]:CORRection:CKIT:LOAD
:MODify:ZOFFset? #25~100[OHM]#
NR1 Sets or queries the cal kit load
standard offset impedance
value.
SENSe[1|2]:CORRection:CKIT:MODify
[:SElect]
<TYPenf|TYPenm|UD1|TYPe35mm
|TYPeff|TYPe716f|TPe716m|UD2
|TYPeapc7|UD3|UD4|...|UD10>
CHAR Selects or queries the cal kit
connector type. Select
TYPe716f or TYPe716m for
modifiable cal kit.
SENSe[1|2]:CORRection:CKIT:NAME
<KIT1|KIT2|...|KIT10>,<STRING>
STRING Sets the description of the
user-defined calibration kit.
SENSe[1|2]:CORRection:CKIT:OPEN
:MODify:CONE? #-10000~1[FARAD]#
NR3 Sets or queries the cal kit open
standard fringe capacitance C1
(f
1
, Farad/Hz) value.
SENSe[1|2]:CORRection:CKIT:OPEN
:MODify:CTHRee? #-10000~1[FARAD]#
NR3 Sets or queries the cal kit open
standard fringe capacitance C3
(f
3
, Farad/Hz
3
) value.
SENSe[1|2]:CORRection:CKIT:OPEN
:MODify:CTWO? #-10000~1[FARAD]#
NR3 Sets or queries the cal kit open
standard fringe capacitance C2
(f
2
, Farad/Hz
2
) value.
SENSe[1|2]:CORRection:CKIT:OPEN
:MODify:CZERo? #-10000~1[FARAD]#
NR3 Sets or queries the cal kit open
standard fringe capacitance
model C0 (f
0
, Farad) value.
SENSe[1|2]:CORRection:CKIT:OPEN
:MODify:DELay? #0~1e-06[S]#
NR3 Modifies or queries the cal kit
open standard offset delay
time.