Agilent Technologies 8712ET - Page 238

11-40 Programmer’s Guide
SCPI Command Summary
SCPI Device Command Summary
Table 11-19 SENSe (3 of 16)
SUBSYSTEM COMMANDS FORM DESCRIPTION
SENSe[1|2]:CORRection:CKIT:OPEN
:MODify:LOSS? #0~1e+12#
NR3 Modifies or queries the cal kit
open standard offset loss value.
SENSe[1|2]:CORRection:CKIT:OPEN
:MODify:ZOFFset? #25~100[OHM]#
NR3 Modifies or queries the cal kit
open standard offset
impedance value.
SENSe[1|2]:CORRection:CKIT:PRESet
[:IMMediate]-?
[<KIT1|KIT2|...|KIT10>]
Command
Only
Sets all values of all
user-defined cal kits to the
default values.
SENSe[1|2]:CORRection:CKIT:SAVE?
<KIT1|KIT2|...|KIT10>
CHAR Saves the user-defined cal kit
or queries whether the selected
user-defined cal kit has been
saved.
SENSe[1|2]:CORRection:CKIT:SHORt
:MODify:DELay? #0~1e-06[S]#
NR3 Modifies or queries the cal kit
short standard offset delay
time.
SENSe[1|2]:CORRection:CKIT:SHORt
:MODify:LOSS? #0~1e+12#
NR3 Modifies or queries the cal kit
short standard offset loss
value.
SENSe[1|2]:CORRection:CKIT:SHORt
:MODify:ZOFFset? #25~100[OHM]#
NR1 Modifies or queries the cal kit
short standard offset
impedance value.
SENSe[1|2]:CORRection:CKIT:THRU
:MODify:DELay? #0~1e-06[S]#
NR3 Modifies or queries the cal kit
thru standard offset delay
time.
SENSe[1|2]:CORRection:CKIT:THRU
:MODify:LOSS? #0~1e+12#
NR3 Modifies or queries the cal kit
thru standard offset loss value.
SENSe[1|2]:CORRection:CKIT:THRU
:MODify:ZOFFset? #25~100[OHM]#
NR3 Modifies or queries the cal kit
thru standard offset impedance
value.