Programmer’s Guide 11-53
SCPI Command Summary
SCPI Device Command Summary
Table 11-19 SENSe (16 of 16)
1. Numeric parameters may include an appropriate suffix; if no suffix is included, the
default (HZ for frequency or S for time) is assumed.
2. Binary parameters accept the values of 1 (on) and 0 (off) in addition to ON and OFF
S
21
.
SUBSYSTEM COMMANDS FORM DESCRIPTION
SENSe[1|2]:SWEep:POINts <num> NR1 Sets the number of data points for
the measurement — choose from
3|5|11|21|51|101|201|401|8
01|1601.
SENSe[1|2]:SWEep:TIME <num>
1
NR3 Sets the sweep time.
SENSe[1|2]:SWEep:TIME:AUTO
<ON|OFF|ONCE>
2
CHAR or
NR1
Turns the automatic sweep time
function on/off.
SENSe:SWEep:TRIGger:SOURce
<char>
CHAR Sets the trigger source for each
point in a sweep — choose
IMMediate or EXTernal (used in
conjunction with
TRIGger[:SEQuence]:SOURce).
SENSe[1|2]:WINDow[:TYPE] <char> CHAR Sets the window selection for
fault location measurements.
Choose from RECTangular
(Minimum), HAMMing (Medium),
or KBESsel (Maximum). (For use
with fault location
measurements on analyzers with
Option 100 only.)
To Next Page
Loading...
