11-62 Programmer’s Guide
SCPI Command Summary
SCPI Device Command Summary
Table 11-23 SYSTem (4 of 8)
SUBSYSTEM COMMANDS FORM
DESCRIPTION
SYSTem:COMMunicate:LAN:NFS
:MOUNT:LIST:REMHost? #1-7
STRING Selects the remote host name (or
host IP address) for an NFS device.
SYSTem:COMMunicate:LAN:NFS
:UNMount-? <string>
NONE Selects the NFS device table.
SYSTem:COMMunicate:LAN:PRINter
:HOSTname <string>
STRING Specifies the IP address of the LAN
printer.
SYSTem:COMMunicate:LAN:ROUTe
:GATeway <string>
STRING Sets the IP address for a LAN
gateway.
SYSTem:COMMunicate:LAN:ROUTe
:SMASk <string>
STRING Sets the subnet mask.
SYSTem:COMMunicate:LAN:SCPI
:SOCKet:PORT <num>
NR1 Selects the port number for a socket
connection to the analyzer for SCPI
socket programming.
SYSTem:COMMunicate:LAN:SICL
:GPIB:ADDRess #0~20, 22~30#
NR1 Sets the GPIB address for SICL
LAN.
SYSTem:COMMunicate:LAN:SICL
:GPIB:LU #0~1024#
NR1 Sets the GPIB logical unit number
for SICL LAN.
SYSTem:COMMunicate:LAN:SICL
:GPIB:NAME <string>
STRING Sets the GPIB name for SICL LAN.
To Next Page
Loading...
