1 Installing the GC
44 Installation and First Startup
A single LAN communications cable is supplied with the GC. The switch (or hub) and other
cables must be ordered separately, if needed. See Table 8 and Table 9 for cabling
requirements for other configurations.
Table 8 Cabling requirements
8860 Series GC connected to: Required Cable(s) Part number
Samplers
7693A Automatic Liquid Sampler Injector cable or tray cable G4514-60610
7650 Automatic Liquid Sampler Injector cable G4514-60610
7683 Automatic Liquid Sampler Injector cable is integral
Tray cable G2614-60610
7697A Headspace Sampler Remote, 9-pin male/6-pin connector G1530-60930
G1289B/G1290B Headspace Sampler Remote, 9-pin male/6-pin connector G1530-60930
CTC automatic sampler Cable, 4 conductor, remote start G6500-82013
Mass Spectrometers and MS
systems
Mass Selective Detector Remote, 2-m, 9-pin male/9-pin male G1530-61200
GC / Agilent external sampler / MS or MSD
system (for example, GC/HS/MSD or
GC/Thermal Desorber/MSD)
Y-Cable, remote start/stop G1530-61200
GC / TMS-9800/ MS or MSD system Y-Cable, remote start/stop
Interface cable for Agilent 6890/7890/8890 to P&T
G1530-61200
14-6689-086
Integrators
3395B/3396C Integrator Remote, 9 pin/15 pin
Analog, 2 m, 6 pin
03396-61010
G1530-60570
Non-Agilent Integrator General purpose analog signal cable 2 m, 6 pin G1530-60560
Non-Agilent data system General use remote,
9-pin male/spade lugs
(various lengths)
35900-60670 (2 m),
35900-60920 (5 m),
35900-60930 (0.5 m)
Other devices
Non-Agilent
instrument, unspecified
External event, 8 pin/spade lugs (No label. See “Labeling
BCD and EVENT cables” on page 56.)
G1530-60590
Valco pulser module (used with PDHID) Valve pulser module power supply cable (includes green
EVENT label)
G1580-60730
Stream selection valves
Gas sampling valves (external)
See documentation accompanying the valve
External valve cable (includes green EVENT label) G1580-60710
LAN
LAN Cable, networking CAT 5, 25 feet
Cable, LAN, crossover
8121-0940
5183-4648
To Next Page
Loading...
Need help?
General
