3-29
Verifying Performance
Agilent Technologies 8922M/S Specifications
Operating
Environment
This instrument is designed for indoor use only.
If the instrument is subjected to Agilent Class B condensation, it is recommended
that the instrument be powered up for at least 30 minutes before normal operation.
CAUTION This instrument is designed for use in Installation Category II and Pollution Degree
2 per IEC 1010 and 644 respectively.
CAUTION Before switching on this instrument, make sure that the line voltage selector switch
is set to the voltage of the power supply and the correct fuse is installed. Assure the
power supply voltage is in the specified range.
WARNING: If this instrument is to be energized via an external auto transformer for voltage
reduction, make sure that it’s common terminal is connected to a neutral (earth
pole) of the power supply.
WARNING: If this instrument is not used as specified, the protection provided by the
equipment could be impaired. This instrument must be used in a normal
condition (in which all means of protection are intact) only.
Lifting or Carrying
the instrument
To avoid potential injury, ensure that two people are employed in lifting the
instrument from it’s packaging and at all other times. Before attempting to lift or
carry the instrument, consider the following basic lifting techniques to help avoid
personal injury.
Using both arms to lift instrument
• Reach for the instrument - bend your knees and waist, and keep your back
straight.
• GRASP the instrument firmly.
• LIFT with your legs.
• KEEP your shoulders level.
To Next Page
Loading...
Need help?
General
