Agilent Technologies E7401A Programmer's Guide

222 Chapter 5
Language Reference
CALCulate:MARKer Subsection
Set Span to the Marker Value
:CALCulate:MARKer[1]|2|3|4[:SET]:SPAN
Sets the span to the value of the specified marker frequency. The specified marker
must be in delta mode. Select the delta marker mode with
CALCulate:MARKer[1]|2|3|4:MODE DELTa. This command is not available
in zero span.
Front Panel
Access:
Marker, Delta, Marker –>, Mkr ∆ –> Span
Set Start Frequency to the Marker Value
:CALCulate:MARKer[1]|2|3|4[:SET]:STARt
Sets the start frequency to the value of the specified marker frequency. In delta
marker mode, the start frequency is set to the marker delta value. This command is
not available in zero span.
Front Panel
Access:
Marker –>, Mkr –> Start
Set Center Frequency Step Size to the Marker Value
:CALCulate:MARKer[1]|2|3|4[:SET]:STEP
Sets the center frequency step size to match the marker frequency. In delta marker
mode, the center frequency step size will be set to the frequency difference
between the markers. Select the delta marker mode with
:CALCulate:MARKer[1]|2|3|4:MODE DELTa. This command is not
available if the delta marker is off, or in zero span.
Front Panel
Access:
Marker –>, Mkr –> CF Step
Peak Search (or Search), Meas Tools, Mkr –> CF
Set Stop Frequency to the Marker Value
:CALCulate:MARKer[1]|2|3|4[:SET]:STOP
Sets the stop frequency to the value of the active marker frequency. In delta marker
mode, the stop frequency is set to the marker delta value. This command is not
available in zero span.
Front Panel
Access:
Marker –>, Mkr –> Stop
Marker On/Off
:CALCulate:MARKer[1]|2|3|4:STATe OFF|ON|0|1
:CALCulate:MARKer[1]|2|3|4:STATe?

Agilent Technologies E7401A Specifications

General

Brand	Agilent Technologies
Model	E7401A
Category	Measuring Instruments
Language	English