Agilent Technologies E7401A

Chapter 5 251
Language Reference
INITiate Subsystem
Front Panel
Access:
Meas Control, Pause
Restart the Measurement
:INITiate:RESTart
This command applies to measurements found in the
MEASURE menu. Use this
command to restart the present measurement from the “idle” state, regardless of its
operating state. It is equivalent to :INITiate[:IMMediate] for single
measurement mode, or :ABORt for continuous measurement mode.
Front Panel
Access:
Restart
Meas Control, Restart
Resume the Measurement
:INITiate:RESume
This command applies to measurements found in the
MEASURE menu. Use this
command to resume the current measurement by changing the current
measurement state from the “paused” state back to the “wait for trigger” state.
Front Panel
Access:
Meas Control, Resume