294 Chapter 5
Language Reference
[:SENSe]:FREQuency Subsection
Frequency Synthesis State
[:SENSe]:FREQuency:SYNThesis:AUTO OFF|ON|0|1
[:SENSe]:FREQuency:SYNThesis:AUTO?
This command switches between auto and manual phase noise selection.
When in auto mode, the phase noise optimization is set as follows:
•
For spans ≤ 10 MHz, the analyzer is optimized for phase noise.
• For spans > 10 MHz, the analyzer is optimized for fast tuning.
This command is available for the following models only:
E7402A, E7403A, E7404A, E7405A
Factory Preset
and *RST: On
History: Added with firmware revision A.08.00.
Front Panel
Access:
AUTO COUPLE, PhNoise Opt
To Next Page
Loading...
