Agilent 1260 Infinity VWD User Manual 61
Using the Detector
4
Setting up an Analysis
Figure 19 Detector Settings (default)
• 1 signal with individual wavelength setting
• stop and post time can be set (if required)
• peakwidth depends on the peaks in the
chromatogram, see “Peakwidth Settings” on
page 71.
• time table for programmable actions during the run
• Zero Offset Limits: 1 – 99 % in steps of 1 %
• Attenuation Limits: 0.98 – 4000 mAU at discrete
values for either 100 mV or 1 V full scale
• additional signals can be stored with the normal
signal (for diagnostics)
• autobalance to zero absorbance (on the analog
output plus offset) at begin and/or end of run
• see “Special Setpoints” on page 70.
To Next Page
Loading...
