AIRTRONICS MT-S - Page 61

61
TR
MT- S
2.4GHZ FH4T RADIO SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
Section Continued on Next Page
BATTERY MENU

TRANSMITTER LOW VOLTAGE ALERT AND LIMIT ALARMS

SYSTEM
SYSTEM MENU
DRYx4
NI-MHx4
LiFex2
LiPox2
4.6 Volts
4.2 Volts
6.3 Volts
7.2 Volts
4.0 Volts
4.0 Volts
6.1 Volts
7.0 Volts
BATTERY TYPE ALERT VOLTAGE
LIMIT VOLTAGE
4-Cell Alkaline
4-Cell Ni-CD/NiMH
2S LiFe
2S LiPo
PRESET
The table below shows the different Battery Type Presets.
Changing the Battery Type Preset:
1) FromwithintheSYSTEMmenu,presstheUPorDOWNkeystohighlighttheBATTERY
menu.
2) PresstheENTERkeytoopentheBATTERYmenu.TYPEDRYx4willbehighlighted.
3) Press the ENTER key, then press the UP or DOWN keys to choose the desired Battery
Type Preset. Choose a Preset that matches the type of transmitter battery you're using.
If you choose CUSTOM, skip to the Changing the Low Voltage Alert Alarm Value and
the Changing the Low Voltage Limit Alarm Value sections below.
Changing the Low Voltage Alert Alarm Value (Custom):
If you choose a Custom battery type, you can change the Alert Voltage value to something
different than the Preset value, which might better suit your specific battery type.
1) FromwithintheBATTERYmenu,presstheUPorDOWNkeystohighlightALERT
VOLT 4.6v.
2) Press the ENTER key, then press the UP or DOWN keys to choose the desired Alert
Voltage value. Increasing the Alert Voltage value will cause the Low Voltage Alert
alarm to sound at a higher voltage and Decreasing the Alert Voltage value will cause
the Low Voltage Alert alarm to sound at a lower voltage. The Alert Voltage value
cannot be set lower than the Limit Voltage value.
BATTERYALERTVOLTsettingrangeis4.1vto9.0v.Thedefaultsettingis4.6v.
The MT-S transmitter features two different programmable Low Voltage alarms.
ALERT VOLT - The Low Voltage Alert alarm will sound to indicate the transmitter batteries are getting low and should be
replaced or recharged. We suggest stopping use as soon as safely possible and replacing or recharging the transmitter
batteries. The Low Voltage Alert alarm will sound each time the transmitter battery voltage decreases by 0.1 volt. To clear
this alarm, press the ENTER or BACK key.
LIMIT VOLT - The Low Voltage Limit alarm will sound to indicate the transmitter batteries are low and should be replaced
or recharged right away. The Low Voltage Limit alarm cannot be cancelled. When
the Low Voltage Limit alarm sounds, you should stop use as soon as it's safe, then
replace or recharge the transmitter batteries. This alarm can only be cleared by
turning the transmitter OFF and replacing or recharging the transmitter batteries.
Changing the Low Voltage Limit Alarm Value (Custom):
If you choose a Custom battery type, you can change the Limit Voltage value to something
different than the Preset value, which might better suit your specific battery type.
1) Fromwithin the BATTERYmenu, presstheUPor DOWN keys to highlightLIMIT
VOLT 4.0v.
If a Battery Type Preset is selected, you cannot change Alert Voltage or Alert Limit values. To be able to change these
valuesyoumustchooseBATTERYTYPECUSTOM.