Page 118
Chapter 6: Creating and Editing Programs
Accessed by pressing the Note Variation ASSIGN key. This is
described in the “Basics” chapter of the manual.
How to create a program
To create a program, either copy an existing program and modify it,
or start a new one:
1. Load in from disk the sounds you intend to use in the program.
2. If you want to change the note number assignments for any of the
pads, press the MIDI key and select option 1.
3. For each pad you want to assign to a sound, select that pad’s note
number in the “Select Programs, Assign Sounds” screen and
assign it to the desired sound and sound assignment mode. This
screen is accessed by pressing the PROGRAM/SOUNDS key and
selecting option 1.
4. If desired, modify the default settings for envelope, velocity
modulation, tuning, poly mode, cutoff assignments, or filter
settings. These are accessed by selecting options 2 or 3 from the
PROGRAM/SOUNDS key menu.
5. If desired, adjust the stereo or individual output/effect mixes or
add effects by pressing the MIXER/EFFECTS key and selecting
the appropriate option.
To Next Page
Loading...
Need help?
General
