Akai MPC 3000 User Manual

Page 183
Chapter 9: Saving to and Loading from Disk
sound files used by the PGM files). Next, the first ALL file (all
sequences and songs) that is found will be loaded.
To cause specific programs, sounds, sequences, and songs to load
automatically when power is turned on, save a single APS file to a
disk that contains the desired programs and sounds, then save an
ALL file that contains the appropriate sequences and songs to the
same disk. Insert this disk in the drive and turn the power on—the
APS and ALL files will load automatically.
If you have a SCSI hard disk connected
If you have a SCSI hard disk connected and no floppy disk is in the
drive when power is turned on, the MPC3000 will load the following
files from partition A of the hard disk automatically: STARTUP.APS
(and all sound files used by that file) and STARTUP.ALL.

Akai MPC 3000 Specifications

General

Polyphony	32 voices
Sampling Rate	44.1 kHz
Sampling Resolution	16-bit
Memory	2MB (expandable to 16MB)
Pads	16 velocity and pressure sensitive pads
Sequencer	Yes
Sequencer Resolution	96 PPQ
Storage	3.5" floppy disk drive
MIDI	In, Out, Thru
Display	LCD
Outputs	stereo output
Inputs	2 x 1/4" inputs