Page 9
MPC3000 Software Update Version 3.1 Operator’s Manual
• The <Make active> soft key:
Press this soft key to make the connected SCSI hard disk active. Whenever
the MPC3000 is turned on, it automatically performs the same function as
pressing this soft key. In either case, the Status field will subsequently
show that the hard disk is active.
Hard Disk Format now allows selection of SCSI address
When formatting a SCSI hard disk, it is now possible to specify the SCSI
address of the hard disk to be formatted. Press DISK, 9, then 3 to go to the
Format Hard Disk screen:
=========== Format Hard Disk ===========
SCSI address:AUTO
Formatting will erase all existing data
and divide the disk into 'partitions' of
less than 30 megabytes each.
========================================
<Next screen>
The new field, SCSI address, has the same function as the SCSI
device to make active field described above— it contains the
address (0 - 6) of the external SCSI hard disk to be formatted. If the only SCSI
device connected is the hard disk to be formatted, enter AUTO here and the
MPC3000 will automatically determine its SCSI address. (It is strongly rec-
ommended to have no other SCSI devices connected during a hard disk for-
mat.) If more than one SCSI device is connected, enter here the SCSI address
of the hard disk drive to be formatted (0 - 6).
To Next Page
Loading...
Need help?
General
