Chapter 3: Recording Sequences
Page 65
TIMING CORECT (Timing correct):
Press to duplicate the function of pressing TIMING COR-
RECT. This is very useful for hands-free use of the Note
Repeat function.
‘+’:
Press to duplicate the function of turning the data entry
control one step to the right.
‘-’:
Press to duplicate the function of turning the data entry
control one step to the left.
RECORD IN/OUT:
Press once to duplicate the function of punching in to Record
mode while playing; press again to duplicate the function of
punching out of Record mode and back into Play mode.
OVRDUB IN/OUT (Overdub in/out):
Press once to duplicate the function of punching in to
Overdub mode while playing; press again to duplicate the
function of punching out of Overdub mode and back into
Play mode.
‘<’:
Press to duplicate the function of pressing the REWIND [<]
key. This is very useful for stepping backward through the
sequence while Step Edit is on.
‘>’:
Press to duplicate the function of pressing the FAST FOR-
WARD [>] key. This is very useful for stepping forward
through the sequence while Step Edit is on.
TAP TEMPO:
Press to duplicate the function of pressing the TAP TEMPO
key.
• The Free seq mem field:
This field shows the total amount of sequence memory currently
available for recording. It is for display only and cannot be edited.
The soft keys:
• The <Init PAR> soft key:
Pressing this soft key presents a screen used for initializing all
general system parameters, which are stored in PAR files. This
function is described in the following section of this chapter.
To Next Page
Loading...
Need help?
General
