Akai S3000XL

INTRODUCTION
Page 4 S3000XL Operator’s Manual
• EDITING FEATURES
EDIT SAMPLE Trim, Loop (with FIND and CROSSFADE functions), Join,
Merge, Splice, Chop, Extract, Reverse, Gain normalisation,
Timestretch, Re-sample.
EDIT PROGRAM Resonant lowpass filters, ADSR envelope generator (with
templates), multi-stage envelope generator (with
templates), 2 x multi-wave LFOs, sample layering, 4-way
velocity crossfade and switching, keygroup crossfade,
portamento (rate and time modes), monophonic legato
triggering, mute group function, panning and autopanning,
held pitchbend mode, separate pitchbend up/down
ranges, output selection. (With 2nd filter bank installed, a
further set of multi-mode filters and a third multi-stage
envelope generator are added).
MULTI Part select, program select, MIDI channel, level, pan,
transpose, fine tune, output routing, FX routing, FX send,
low key range, high key range, note priority.
EFFECTS In the two multi-effects channels (with the EB16 effects
processor installed):
DISTORTION - distortion, level
EQ - low gain, mid gain, high gain,
RING MODULATION - frequency, depth
MODULATION EFFECTS - chorus, flange, phase shift,
rotary speakers, autopan/frequency mod, pitch shift with
parameters as appropriate.
DELAY - effect select (mono, stereo, ping pong), delay
times, feedback.
REVERB - effect select (large hall, small hall, large room,
small room, gated, reverse, etc.), size, decay time, HF
damping, LF damping, pre-delay.
FX DIRECTION:
dist/EQ/ring mod > mod/delay + reverb (parallel)
dist/EQ/ring mod > mod/delay > reverb (series)
dist/EQ/ring mod > reverb > mod/delay (series)
In the two reverb channels:
Effect select (large hall, small hall, large room, small room,
reverse, gated, etc.), decay time, HF damping, LF
damping, pre-delay, diffusion.
A multi-effects channel may also be routed to its
‘neighbouring’ reverb channel for dual reverb multi-effects.