EFFECTS EDIT
S3000XL Operator’s Manual Page 189
PING PONG ECHO EFFECTS
The field allows you to add another repeat element to the echo
effect and takes a ‘tap’ off the delayed signal to produce a secondary repeat. This allows
you to create pseudo stereo ‘ping pong’ echo effects that bounce back and forth from left
to right. A setting of 00 creates a mono echo effect. A setting of +50 will create a ‘ping
pong’ echo effect that goes from right to left and back again. A setting of -50 will create a
‘ping pong’ echo effect that goes from left to right and back again. Settings in between 00
and ±50 will give ‘asymmetric’ or syncopated ‘ping pong’ effects.
For example, with a setting of 500mS and a of ±50, the
result will be equally spaced repeats of 250mS. I.e.:
LEFT
RIGHT
IN
500mS 1Sec 1.5Sec
250mS 750mS 1.25Sec
With settings of, say, ±25, the first repeat will come after 125mS,
the second after 500mS, the third after 625mS, etc. (depending on the amount of
feedback). I.e.
RIGHT
IN
500mS 1Sec 1.5Sec
LEFT
125mS 625mS 1.125Sec
The closer the parameter is set to ±50, the closer the first echo will
be to the value set in the parameter.
To Next Page
Loading...
Need help?
General
