APPENDIX 4
Page 294 S3000XL Operator’s Manual
COPYING A FLASHROM SAMPLE TO RAM
If you really do need to edit a sample in the FlashROM, the original sample will need to be
loaded into RAM. This is done in the LOAD mode.
Go to LOAD and select the volume the sample is in (if you just loaded from it, this should
be the selected volume) and select CURSOR ITEM ONLY:
Move the cursor to the sample you wish to load. Proceeding with CLEAR or LOAD will
then give this second level of prompting:
Pressing F8 - YES - will load the selected sample into RAM where it may be edited as
normal with none of the restrictions described on the previous page. Press F7 - NO - will
‘load’ the sample as a FlashROM sample (i.e. the sample will be played directly from ROM
and you will not be able to perform certain sample editing functions).
NOTE: You will only receive this second level of prompting if the selected single item is a
sample. If you select to load a single program or multi or effects file, the COPY TO RAM?
prompt will not appear.
Alternatively, if you know where the original sample is on disk, you may prefer just to load
it straight from disk, bypassing the procedure described above.
To Next Page
Loading...
Need help?
General
