SAVE
S3000XL Operator’s Manual Page 207
SAVING TO HARD DISK
In the main SAVE page, select the media you wish to save to (i.e. hard disk). You will see
something like this screen:
To select the partition to save to, place the cursor on the partition field and use the DATA
wheel to select the partition. Now move the cursor to the field and select the volume
you wish to save to.
NOTE: You may, if you wish, press F2 - - to see a list of the selected partition
volumes and select a volume to save to
You may scroll through the list of available volumes on the current partition. If the volumes
have been named, you will see the names of the volumes otherwise, the volume name
will show VOLUME ??? where ? is the default, unnamed volume number (it is good
practice to name volumes to keep better track of things when loading - see below for
information on naming volumes).
When you have selected the one you wish to save to, press F1 - - which will take
you to the main SAVE screen for the selected volume.
Move the cursor to the field and use the DATA wheel to make your
selection from the options listed above. Now, either press WIPE or GO as you wish.
WIPE will first erase the hard disk volume completely (BE CAREFUL!!) and then save the
file(s). You will receive the following prompt:
You should press F7 or F8 as appropriate.
GO will simply save the file(s) without erasing the volume first.
If, for some reason, there is a problem with the hard disk (i.e. it is not connected or not
switched on or, if it’s a removable medium of some sort and the disk/cartridge is not
inserted or write protected), you will receive the message:
You will also receive this message if you try to save to a CD-ROM which, of course, is a
read-only medium.
To Next Page
Loading...
Need help?
General
