EFFECTS EDIT
Page 188 S3000XL Operator’s Manual
MONO DELAY/ECHO EFFECTS
If you selected either of the MONO echo effects, the screen you will see is something like
this:
The parameters are:
Here, you may set a delay time of up to 700mS
This sets the amount of repeats the echo effect will have by setting how
much of the delayed output is fed back into the delay line.
NOTE: Be careful with high settings as you can cause the delay line to go
unstable and cause ‘howl around’.
This sets the high frequency damping. The HF DAMP parameter filters out
some of the high frequency components in the sound in the feedback
loop. This is to simulate the effect that in real life, each repeat of the echo
gets slightly duller as the surfaces off which the sound is bouncing absorb
some of the high frequencies. The value shown is the frequency that will
be attenuated in the feedback loop.
This selects where you will listen to the output of the delay and allows you
to set the direction of the modulation section and the echo section. You
may select POST which will give the effect of echo followed by the mod
effects or you may select PRE which will give the effect of the mod effects
followed by echo.
NOTE: When PRE is selected, you must set a value in the parameter to hear
any delay effect
NOTE REGARDING MONO ECHO EFFECTS
Please note that because the stereo mod section passes through the echo section, any
stereo mod effects you create will be ‘monofied’ when mono delay effects are selected.
To enjoy stereo modulation effects with echo, please choose the stereo delay option (see
below).
To Next Page
Loading...
Need help?
General
