EFFECTS EDIT
S3000XL Operator’s Manual Page 173
EFFECTS EDIT
As we have seen, there are 50 ‘effects’ presets (i.e. presets for the distortion/EQ/ring
mod/modulation/delay effects sections of the multi-effects channels) which can be freely
assigned to the two multi-effects channels FX1 and FX2. These multi-effects presets have
associated with them, a reverb preset so that multi-effects and reverb are always selected
whenever you select a new multi-effect preset. The reverb presets associated with the
effects are drawn from the ‘pool’ of 50 reverb presets. Our programmers have put
together a wide palette of multi-effects types to suit a variety of different purposes which
we hope you find useful. However, with so many effects to choose from and with such a
wide range of parameters and possible combinations, it may be that you will need to edit
these to your requirements. To edit any of these presets, first press EFFECTS and select
the effect you want to edit. Once you’ve done that, press EDIT.
NOTE: Editing an effect and/or reverb preset will, however, affect any sound that uses
that preset. For example, you may have a guitar sound that uses effect preset #4 which is
set to chorus and delay. However, if for the purposes of the guitar sound, you add
distortion and EQ and change the chorus to a flange setting, if there is another program
in memory that uses that effect preset (for example, a strings program), it too will be
affected.