LOAD
S3000XL Operator’s Manual Page 219
LOADING FROM FLOPPY DISK
In the main LOAD page, select the media you wish to save to (i.e. floppy). You will see
something like this screen:
Now make your selection in the field by moving the cursor to this field
and use the DATA wheel to make your selection. Now, either press CLR or GO as you
wish. Pressing (CLEAR) will delete all programs and samples from memory, and
then load the chosen file(s) from disk(BE CAREFUL NOT TO ERASE ANYTHING YOU
WANT TO KEEP THAT HASN’T BEEN SAVED TO DISK!!). You will receive this prompt to
check you want to clear the memory:
You should make the appropriate NO or YES response.
Pressing will load the chosen file(s) into memory without deleting anything first. As
the disk is being loaded you will receive something like the following display to keep you
aware of progress:
It is possible that the chosen file(s) will occupy more memory space than is actually
available, in which case the loading process will be halted and you will receive this prompt:
Any files which have been completely loaded into memory prior to the prompt will remain
in memory, however.
If no floppy disk is in the drive, you will be prompted:
If the disk is un-formatted (or has become seriously damaged in some way) the S3200 will
tell you:
You should format the disk (see SAVE - FORMATTING).
To Next Page
Loading...
Need help?
General
