Automatic Performance Tests
155
results are available in Port B. On the other hand, if you have configured Two-way
(A > A), Upstream or Downstream, the RFC 2544 results are available in Port A.
3. Select RFC 2544.
4. Check the Status field to know the pass / fail test result. If the test has not yet fin-
ished, this field will display a In progress message. If the equipment detects an
error during text execution it will display an error message.
Figure 7.1: RFC 2544 test results: (a) Throughput results table, (b) Latency results table.
(a)
(b)
To Next Page