269
Chapter 11
Test Management
This chapter describes all those features available in your test unit that are not directly
related with configuring your tester or reading measurement results but they are
important for proper test management. Specifically, configuration and result
management, report generation and test platform settings are covered in the following
sections.
11.1.Generating Reports
Users may want to generate reports based on their measurements. Reports are
important to save results for later reference. Reports can be used to share a test result
or to include results in documents.
Depending on the purpose of the report, users have different ways to generate and
store them. The test unit offers maximum flexibility and at the same time simplicity
when configuring reports. Follow these steps to configure and generate a report:
1. From the Home panel, go to File (),
The tester file manager base menu is displayed.
2. Select Report files to go to the report file settings
3. Enable report generation by means the Generate reports control.
4. Set the Report format, Report named after and Report header fields.
5. If you have set Report named after to User ref.+sequence, configure the User ref-
erence field to the desired sequence.
6. Optionally, if you have configured Report named after to User ref.+sequence or
Serial no.+sequence, enter the Next sequence number to be applied to the next
report.
7. Set the correct action to be carried out when the internal storage is full.
If report generation is enabled, a new report is generated each time a test finishes
either by pressing the run button or automatically. Reports are available as standard
To Next Page